I would pull over on the shoulder and cut off the car about 1-2 minutes and restart it. If the bulb lights and is bright, wiggle-test the harness. It is common to see the throttle control motor supply voltage low due to a poor throttle motor relay. When the customer went to Autozone and had the codes read, they suggested that it was the throttle control actuator, so the customer decided to order the part from the Nissan dealership and install it himself. I purchased the car not running properly.
Found this plug, it seemed secure but unplugged it and then put it back and it began working fine. In later car models, the car's computer can usually keep the vehicle running, but the engine warning light on the dashboard goes on to warn the driver. Connect all the harness connectors. Remember that the customer already replaced the throttle control actuator himself, in hopes of a simple fix. Went for a used ipdm from pull a part, Replaced ipdm. The P1122 is typically set when the throttle control function does not operate properly. Needless to say, this did not fix his vehicle.
I know this didn't fix the problem because the check engine light is still on, but is this helping one of the above problems so I could narrow this down to which one to repa Oct 11, 2010 I had the same problem before. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. She had been wearing a big pair of boots and we can only assume she somehow knocked the plug as it was working fine before this. The need your core or you will need to pay extra money. We were certain that the codes plus some simple diagnostic procedures would send us to the culprit.
Motor relay power supply circuit. The judges the current opening angle of the throttle valve from these signals and the controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition. In later car models, the car's computer can usually keep the vehicle running, but the engine warning light on the dashboard goes on to warn the driver. If no good: replace and proceed to next step. You can find this list many places on the Web.
If either sensor isn't working correctly, the car will run rough and the engine will be less efficient. That creates a vacuum throughout the entire fuel storage system. I have an 02 Altima 2. I would pull over on the shoulder and cut off the car about 1-2 minutes and restart it. Please check b P1122 code. If no good: replace the fuse 9.
Now don't ask yourself; What should you do with P1122 code? I know this didn't fix the problem because the check engine light is still on, but is this helping one of the above problems so I could narrow this down to which one to repa Posted on Oct 11, 2010 Definition Electric throttle control malfunction Probable Causes 1 Stuck or Sticking throtte plate 2 Poor electrical connection 3 Failed throttle control actuator When I'm driving on the highway the car would lose all power to the gas pedal. For the heck of it, look at the pedal and insure that that plug is securely connected. The throttle position sensor detects the throttle valve position, and the opening and closing speed of the throttle valve and feeds the voltage signals to the. They are independent publications and are not affiliated with or endorsed by or. I couldn't find codes for the Sunny, so I went with the 2004 Nissan Sentra, which has an electronically controlled throttle body throttle by wire system.
The problem would occur about 3 times per day. I will take you about ten to twenty minutes to replace it. The vehicle service manual should be consulted for more information on possible causes of the fault, along with required testing. Take the intake air duct out Look for dirt grease etc. Car starts no problem,idles, but no response when pressing gas pedal at all. Also when I fill up I put gas treatment in the fuel take along with V-Power gas.
If either sensor isn't working correctly, the car will run rough and the engine will be less efficient. If no good: clean the inside of the actuator. The computer notices the canister is empty when it detects a leaner condition all the vapors are used up and it resumes normal fuel delivery. The solution is here : Nissan X-Trail P1122 Possible Solution : The crankshaft sensor signals the fuel injection computer or the ignition control when the cylinders are firing. Which should ign on batt volts. After performing the standard diagnostic tests above, one of my techs decided to go a different route.
The on-board diagnostics system and engine control unit are in charge of monitoring a bunch of different, and if they get a reading that's a little out of whack, up pops the check engine light. Loosen and tighten the body screws. Ever since I started doing this the car never cut off. And I will dig deeper for more information. Check the resistance of the throttle control motor. My daughter's did this and I was scratching my head.